Pearl & Glitter Ribbon Garland DIY

My original idea was just to easily string these jumbo pearls through the ribbon, knot either side, and call it a day. The pearl holes, however, weren't large enough for my glitter ribbon to fit through and I didn't want to spend all day trying to make the holes larger. So instead I went with a jewelry-making technique and attached each pearl with head pins. It took longer than simply stringing them but without too much effort. If you're going for a more woodsy look on your tree or holiday decor, raw wooden beads would be a really cute alternative {even with the glitter ribbon!}... and they have very large holes so stringing wouldn't be an issue at all.




* Glitter Ribbon in slate by American Crafts
* Jumbo pearls & Seed pearls
* Head pins
* Beading pliers
* Wire cutters




* Thread a seed pearl then a jumbo pearl onto your head pin.



* Using your pliers, bend the top of your head pin into an medium sized L {your ribbon has to fit through it}



* Clip the length off of the end with your wire cutters.



* Pinch your ribbon and slide it into the L.



* Clamp it closed with your pliers.



* Pinch the end of your ribbon and make a slanted cut to create a finished edge.









Get Christmas Crafty with me and link up yours below! {no dupes please}

* See all Christmas Crafts here!

* FACEBOOK * TWITTER * BLOGLOVIN' *

---

Tweet This!